Breville the Grind Control (BDC650BSS)
Manual troubleshooting covers a grinder that clogs when the chute is damp. Maker source.
As an Amazon Associate I earn from qualifying purchases. Some links on this page are affiliate links — if you buy through them, we may earn a commission at no extra cost to you. Disclosure
Jump to the machines for this topic
Short answer: most grind-and-brew problems come from three things — a damp grinder chute, too much or too-fine coffee in the basket, and parts not seated so a safety switch stops the machine. Unplug before checking anything.
Manual troubleshooting covers a grinder that clogs when the chute is damp. Maker source.
Cuisinart lists brew pause and a grind-off setting for pre-ground coffee — handy while you sort out a grinder problem. Maker source.
| Symptom | Likely cause (manual) | Fix |
|---|---|---|
| Grinder runs loud but no coffee comes out | Moisture or a foreign object clogging the grinder (Breville Grind Control) | Unplug, clear the chute, dry burrs and chute completely (a hair dryer is allowed), restart only when dry |
| Grounds stick, flow slows over weeks | Oily or frozen beans leaving residue in the feeder channel (Capresso) | Clean the feeder channel; switch beans; see oily bean advice |
| Filter basket overflows | Too much coffee, grind too fine, or carafe out longer than 20 s during Sneak-a-Cup (BLACK+DECKER) | Use less coffee or a coarser grind; return the carafe within 20 s |
| Water leaks from the machine | Reservoir filled past the 12-cup MAX, or carafe not placed correctly (BLACK+DECKER) | Fill only to MAX; seat the carafe fully |
| "LOCK BEAN HOPPER" message | Hopper not locked, or beans blocking the lock (Breville) | Remove beans from the lock area and turn the hopper to lock |
| "EMPTY COFFEE FILTER" message | Filter basket not seated or door not closed (Breville) | Reseat the basket and close the door |
| "FILL TANK" message | Not enough water (Breville) | Fill the tank |
| Fine sediment in the cup | Gold-tone filter lets some fines through — normal (Breville) | Use a flat-bottom paper filter (8–12 cup, about 3¼ in base) |
| Coffee too strong / uses lots of beans | Strength set high (Breville) | Lower the strength setting; check the dose with the ratio calculator |
| Machine prompts to descale | Mineral build-up (De'Longhi TrueBrew) | Descale with De'Longhi descaler — steps in the cleaning guide |
Sources for the table: Breville Grind Control troubleshooting · Capresso GS instructions · BLACK+DECKER CM5000 troubleshooting · TrueBrew instructions.
| Model / symptom | What the booklet says | What to do |
|---|---|---|
| DGB-400/450: beeps continuously, won't start | Reservoir cover open or grinder cover left out; safety interlock prevents operation | With the machine off, reinstall missing parts and close the lid until it locks. Press Brew/Off to restart; choose Grind Off first if the beans have already been ground |
| DGB-400/450: filter basket overflows | Carafe out more than 20 seconds during Brew Pause, or excessive / too-fine ground coffee | Return carafe within 20 seconds. For pre-ground coffee, don't exceed 16 level tablespoons; use either a paper filter OR the permanent filter, not both |
| DGB-400/450: grinder problems after washing | Water can damage the grinder motor if it gets into the area below the removable basket | Unplug. Dry all removable parts completely. Wipe the motor area with a damp cloth only; never pour water into it. If water got into the motor, don't keep trying to run it — arrange service |
| DGB-30: Bold and Power/Brew flash in grind mode | Grinder overloaded | Turn off, unplug, remove hopper and burr, clean the burr, then reinstall both |
| DGB-30: 20 oz, 24 oz, Mild or Ground flashes with Power/Brew | May be overheating | Unplug and wait 30 minutes. If flashing continues after reconnecting, call Cuisinart support |
| DGB-30: won't brew, Power/Brew flashes continuously | Filter basket door open, basket missing or not installed properly | Check basket and close the door fully. If Add Water is on, fill and seat the reservoir |
| DGB-30: weak coffee despite enough beans | Residue in the grinder chute can restrict grounds reaching the basket | Brush the outlet clean; try a smaller brew size or Bold strength after cleaning |
| DGB-30: won't grind | Overpacked beans, jammed burr, hopper not locked, or brew cycle still running | Don't fill to the closed lid. Finish or cancel brewing, then unplug before brushing out the chute and removing the burr. Re-seat and lock hopper |
Cuisinart DGB-400NAS manual, pp. 8–10 · Cuisinart DGB-450NAS manual, pp. 8–10 · Cuisinart DGB-30 manual, pp. 12–13.
A red CLEAN light means mineral build-up on the Cuisinarts, but the quantities and button sequence differ: DGB-400/450 use ⅓ vinegar and ⅔ water at reservoir capacity; DGB-30 uses 13 oz vinegar and 26 oz water. The cleaning and maintenance guide gives each model's sequence and rinse steps. Neither a cleaning light nor slow flow is a reason to add extra coffee — that makes overflows more likely.
Prevention beats fixing: the daily routine is in the step-by-step cleaning guide. If clogs keep happening, the problem may be the machine type — the easiest machines to keep clean have fewer grinder parts, and a separate grinder avoids steam near the burrs altogether.
Specs verified: November 2026 · Updated 2026-11-18 · How we research